Description
Fluke i30s AC/DC Current Clamp (30A)
The Fluke i30s AC/DC Current Clamp (30A) is used to measure AC/DC current and complex waveform currents.
It is not a clamp meter, but is an optional current module that is designed for direct attachment to Fluke oscilloscopes and digital multimeters in order to carry out current measurements up to 30A.
The jaws of this clamp are 19mm in diameter.
- Very accurate
- Flexible current range
- Compatible with other recording instruments
Fluke i30s Technical Specifications
Specified current range | | 30 mA to 30A dc, 30 mA to 20 A ac rms |
|
Usable current range | | 5 mA to 30 A dc, 30 mA to 20 A ac rms |
|
Crest Factor | |
Output sensitivity | |
Accuracy (at 25 °C) | |
Resolution | |
Load impedance | |
Conductor position sensitivity | | ± 1 % relative to center reading |
|
Frequency range | |
Phase shift below 1 kHz | |
Temperature coefficient | |
Power supply | | 9 V Alkaline, MN1604/PP3, 30 hours, low battery indicator |
|
Working voltage (see Safety Standards section) | |
General specifications |
Maximum conductor size | |
Output connection | | Safety BNC connector, supplied with safety 4 mm adapter |
|
Output zero | | Manual adjust via thumbwheel |
|
Cable length | |
Operating temperature range | |
Storage temperature range (with battery removed) | |
Operating humidity | | 15 % to 85 % (non-condensing) |
|
Weight | |
Safety standards | | BS EN 61010-1: 2001 | | BS EN 61010-2-032: 2002 | | BS EN 61010-031: 2002 | | 300 Vrms, Category III, Pollution Degree 2 | | Use of the probe on uninsulated conductors is limited to 300 V acrms or dc and frequencies below 1 kHz. |
|
EMC Standards | | EN 61326: 1998 A1, A2, & A3 |
|