Description
Fluke i310s AC/DC Current Clamp Probe (300A)
The Fluke i310s AC/DC Current Clamp Probe (300A) is designed for use with oscilloscopes, multimeters and other testers that accept standard 4mm jacks in order to carry out measurements of current.
This current testing device can be used to measure current in both AC and DC up to 300A AC and 450A AC. All measurements are carried out with high degrees of accuracy.
Fluke’s i310s is designed to be used with conductors up to 19mm in diameter.
Fluke i310s Technical Specifications
| Current Ranges | | 30 A and 300 A ACRMS or ±45 A and 450 A DC |
|
| ACRMS or DC | |
| Inrush Current | |
| Output Sensitivity | | 10 mV/A (30 A) | | 1 mV/A (300 A) |
|
| Accuracy (at 23°C) | | (30A range) | ±1% of reading ±50 mA | | (300A range) | ±1% of reading ±300 mA |
|
| Bandwidth to meet accuracy specification | |
| Phase Shift below 1 kHz | |
| Resolution | | ±50 mA (30 A) | | ±100 mA (300 A) |
|
| Load Impedance | |
| Conductor Position Sensitivity | | ±1.5% relative to centre reading |
|
| Frequency Range | | (small signal) | DC to 20 kHz (- 3 dB) |
|
| Temperature Coefficient | |
| Power Supply | |
| Battery Life | | 30 Hours, low battery indicator |
|
| Working Voltage (see Safety Standards section) | |
| General Characteristics |
| Maximum Conductor Size | |
| Output Connection | | Safety BNC connector | | Supplied with safety 4mm adaptor |
|
| Output Zero | | Manual adjust via thumbwheel |
|
| Cable Length | |
| Operating Temperature Range | |
| Storage Temperature Range (with battery removed) | |
| Operating Humidity | | 15% to 85% (non-condensing) |
|
| Weight | |
| Safety Standards |
| BS EN 61010-1 | |
| BS EN 61010-2-032 | |
| BS EN 61010-031 | |
| 300 VRMS, Category III, Pollution Degree 2 | |
| Note | | Use of the probe on un-insulated conductors is limited to 300 V ACRMS or DC and frequencies below 1 kHz. |
|
| EMC Standards | | BS EN 61236 | 1998 A1, A2, & A3 |
|
